Udp Echo Operation Configuration Example - HP 5920 Configuration Manual

# After the TCP operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent results of the TCP operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2011-11-22 10:27:25.1
Extended results:
Packet loss ratio: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to internal error: 0
Failures due to other errors: 0
# Display the history records of the TCP operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
The output shows that Device A uses 13 milliseconds to establish a TCP connection to port 9000
on the NQA server.

UDP echo operation configuration example

Network requirements
As shown in
Device B. The destination port number is 8000.
Figure 49 Network diagram
Configuration procedure
1. Assign each interface an IP address. (Details not shown.)
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure Device B:
# Enable the NQA server, and configure a listening service to listen on the IP address 10.2.2.2
and UDP port 8000.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server udp-echo 10.2.2.2 8000
Response
13
Figure 49, configure a UDP echo operation to test the round-trip time between Device A and
Receive response times: 1
Status Time
Succeeded 2011-11-22 10:27:25.1
158