Analog Trunk Card Uni (Atm4U) - Avaya IP500 Installation Manual

9.7.1 Analog Trunk Card Uni (ATM4U)

This card supersedes the previous Analog Trunk cards and is referred to as the "ATM4U". It can be identified by a label on
the base of the card.
The card is supported on IP Office software 2.1(36) and higher. Unlike the previous ATM4 card, the same ATM4U card
variant can be used in all locales.
For systems running IP Office software 3.1 or higher, the echo cancellation used on each trunk can be switched off or on
(16ms).
The card provides 4 RJ45 sockets for
start trunks an Analog Trunk expansion module
· Power Failure Operation
There are no power failure extension connections provided for the analog trunk card. If this is a requirement, the
ATM16 expansion module should be used.
WARNING
·
In all IP Office installations, any module or control unit using analog trunk connections must be connected to a
functional earth
39
WARNING
·
Within the Republic of South Africa and in areas of high lightning risk, any module or control unit using analog trunk
connections must be connected to a
ATM4U Trunk Card
· The card includes two plastic stand off pillars for installation and a replacement blanking plate for the rear of IP400
control units.
· For the IP500 and IP500 V2 control units, an IP500 Carrier Card is required, up to a maximum of 2 IP500 Carrier
Cards.
IP500/IP500 V2 Installation
IP Office 8.0
analog trunk connections
251
.
protective ground
ATM4 Uni (Loop-Start)
. The card only supports loop-start trunks. For ground-
378
should be used.
and to surge protection equipment
39
Country
All
System Components: IP400 Trunk Cards
40
SAP Code IP500
700359938
15-601042 Issue 25i (03 January 2013)
.
IP500
V2
Page 243