Disable Unused Trunks - Avaya IP500 Installation Manual

5.6 Disable Unused Trunks

Each IP Office trunk card provides a fixed number of trunk ports with digital trunk ports supporting a fixed number of
digital channels. By default the IP Office configuration will have settings for all the possible trunks and channels.
In cases where the number of trunks or trunk channels in use or licensed is lower than the number supported by the trunk
card, the unused trunks and channels must be disabled.
Failure to do this will cause problems with outgoing calls. For example, on a system with an ATM4 trunk card
·
fitted but only two analog trunks actually connected, failure to disable the other two trunks within the IP Office
configuration will cause 50% of outgoing call attempts to fail.
!
WARNING
·
This process will require the IP Office system to reboot in order to complete the process. Any current calls and
services will be ended by the reboot.
Disabling Trunks
1. Start IP Office Manager
2. Within the IP Office configuration, select
3. For each line, set those lines or channels that are not connected or being used as out of service. The location of the
relevant setting varies for each trunk type.
· Analog Trunks
To disable the whole trunk, on the main form set the Admin option to Out of Service.
· BRI, E1 PRI, S0 and QSIG Trunks
To disable the whole trunk, on the main form set the Admin option to Out of Service. Otherwise set the
number of channels to match the actual subscribed channels.
IP500/IP500 V2 Installation
IP Office 8.0
and receive the configuration from the IP Office system.
68
Line.
15-601042 Issue 25i (03 January 2013)
Page 110