Avaya IP500 Installation Manual page 151

Erasing the Core Software via the Boot Loader
2. Run Manager.
· In the BOOTP entries, check that there is an entry that matches the MAC Address, IP Address and .bin file
used by the system. An entry is normally automatically created when a configuration has been loaded from
that IP Office. .
· If an entry is not present, create a new entry manually. The first two details can be found in the Control
Unit settings in the configuration file. Then close and restart Manager.
· Under File | Preferences ensure that Manager is set to 255.255.255.255. Also check that Enable BootP
Server is checked.
· Select View | TFTPLog.
· Check that the required .bin file is present in Manager's working directory.
2. Attach the serial cable between the PC and the DTE port on the IP Office control unit.
a. Start the terminal program on your PC. Ensure that it has been setup as listed in
a HyperTerminal session, the current settings are summarized across the base of the screen.
b. Arrange the program windows so that the Terminal program and Manager TFTP Log are visible at the same
time.
c. Switch off power to the IP Office control unit.
d. Power on the control unit and press the escape key every second until you get a Loader message. Below is an
example.
P12 Loader 2.4
CPU Revision 0x0900
e. Enter AT (note upper case). The control unit should respond OK.
f. If an OK response is not received, check the settings of your terminal program and repeat the process above.
3. Enter AT-X. The control unit should respond Multi-Sector Erase.
4. The control unit will now request the .bin file it requires. For IP500 V2 control units this will be from files on the
System SD card. For other control units it will be from Manager and appears in the TFTP Log.
5. If the file transfers does not appear to be taking place, check that the IP address shown in the TFTP Log matches
the BOOTP entry. Adjust the BOOTP entry if necessary.
6. When completed the system will reboot.
IP500/IP500 V2 Installation
IP Office 8.0
Additional Processes: DTE Port Maintenance
DTE Port Settings
15-601042 Issue 25i (03 January 2013)
. Within
146
Page 151