So8 Bri Module; Example 1: Isdn Terminal - Avaya IP500 Installation Manual

6.10 So8 BRI Module

6.10.1 Example 1: ISDN Terminal

In this example, calls on DID 123456 are routed to the first port of the So8 expansion module. That port has been
configured as Line Group ID 701.
1. Configure an Incoming Call Routing
The destination is a short code that directs the call to the line group ID that contains the So lines. The Bearer
Capability has been set to Any, to allow data and voice via this route.
· Line Group ID: 0
· Incoming Number: 123456
· Destination: 123456
· Bearer Capability: Any
2.Create a System Short Code:
This is the destination used in the Incoming Call Route.
· Short Code: 123456
· Telephone Number: 123456
· Line Group ID: 701
· Feature: Dial
3. Send the configuration to the Control Unit.
Any call coming into the main system on DID 123456 will now be passed directly to the first port.
If you wish to assign DIDs from your main pool to individual ports and avoid network charges when dialing between them,
try variations on the following:
1. You have DID ranges, for example: 7325551000 to 7325551099. You wish to assign 7325551000-19 to port 1 and
7325551020-20 to port 2 etc.
2. Configure Incoming Call Route:
The # is used here instead of "n" to avoid problems with "Main". The minus sign means the number is processed from
the left and so will wait for the whole number.
· Line Group ID: 701
· Incoming Number: -100x
· Destination: #
3. Repeat for Line Group ID 702 etc.
4. Create Short codes, for example:
· Short Code: 100x
· Telephone Number: .
· Line Group ID: 701
· Feature: Dial
S0 calls dialed without the area code are handled locally without network charges. Calls with area calls will go via the
network.
IP500/IP500 V2 Installation
IP Office 8.0 15-601042 Issue 25i (03 January 2013)
Page 138