Creating A Configuration File - Avaya IP500 Installation Manual

4.4.2 Creating a Configuration File

IP Office Manager can be used to create a new configuration without connecting to an IP Office system. During the
process, you can specify the locale of the system, what type of trunk cards it uses and what type of control unit and
expansion modules to include.
This allows the creation of a configuration prior to installation of system. The configuration file can be
System SD card before it is installed into the system. Otherwise the configuration can be uploaded to the system using
78
Manager after initial installation of the system.
· The configuration created must match the physical equipment in the IP Office system onto which the configuration
will be loaded. Doing otherwise may cause the IP Office system to reset and experience other problems.
1. Start IP Office Manager with no configuration loaded into Manager
2. Click on Create an Offline Configuration in the simplified view.
3. Select the type of configuration that you want to create. The equipment and settings will be restricted to those
supported in the selected mode.
4. When completed click OK.
5. Manager will create and load the configuration.
6. Edit the configuration to match the customer requirements. This can include importing information from
preprepared CSV files.
7. When completed, select File | Save Configuration As.
IP500/IP500 V2 Installation
IP Office 8.0
IP500 V2 Installation: SD Card Preparation
placed onto the
15-601042 Issue 25i (03 January 2013)
Page 77