5. Initial Configuration Using Ip Office - Avaya IP500 Installation Manual

5. Initial Configuration Using IP Office Manager
This section covers basic configuration changes required for IP Office systems if using the IP Office Manager application.
This covers just the basic configuration, the full range of configuration possible through IP Office Manager is covered in the
IP500/IP500 V2 Manager manual.
Entering Licenses
·
Enter licenses for features that require them.
Setting the System Locale
·
Setting the correct system locale affects a wide range of settings including trunk settings. The correct locale must
be set for a system to operate correctly.
Extension Numbering
·
Renumber the user extensions if required.
Change the Default Passwords
·
The default passwords used for configuration access to the IP Office system should be changed.
Change the IP Address/DHCP Settings
·
If necessary, the IP address and DHCP mode of the IP Office system can be changed.
· Trunk Configuration
Some basic trunk configuration may be required.
Remove Unused Trunks
·
Disabling the use of trunks and trunk channels that are not available.
Select the Clock Source for Digital Lines
·
Altering which digital trunk is used to provide the IP Office with its clock signal for call synchronization.
Enter Trunk Prefixes
·
On systems where a prefix is being used for external dialing, ensure that the same prefix is added to incoming
numbers in order to allow return calls.
IP500/IP500 V2 Installation
IP Office 8.0
103
104
108
106
105
110
114
112
15-601042 Issue 25i (03 January 2013)
Page 102