Ip400 Trunk Cards - Avaya IP500 Installation Manual

1.5.3 IP400 Trunk Cards

IP400 trunk cards can be used in IP500 and IP500 v2 controls units by being fitted onto an
base card. Up to 2 cards can be added to the control unit in this way.
The following IP400 trunk card types are supported in this way by IP Office Release 8.0:
IP400 Trunk Cards
Analog Trunk Card (ATM4)
Provides 4 RJ45 loop-start analog trunk ports. The card is available in several
locale specific variants. This card has been superseded by the ATM4U card
below.
Additional loop or ground start analog trunks can also be added using
Trunk
Analog Trunk Card (ATM4U)
Provides 4 RJ45 loop-start analog trunk ports as per the ATM4 above but
available in a single worldwide variant. Also supports adjustable echo
cancellation on IP Office 3.1.
Additional loop or ground start analog trunks can also be added using
Trunk
Quad BRI Trunk Card
Provides support for 4 RJ45 BRI (2B+D) trunk ports. These can be configured
to ETSI or AusTS013 operation. The ports include 100ohm termination.
Single PRI T1 Trunk Cards
Supports PRI (23B+D) trunks and T1 Robbed-Bit (24B) trunks through a single
RJ45 port. The mode of operation is selected in the IP Office configuration.
Single E1 PRI Trunk Cards
Supports PRI (30B+D) trunks through a single RJ45 port. The port can be
configured for PRI or QSIG operation.
Single E1R2 Trunk Cards
Supports PRI (30B+D) trunks using E1R2 signaling. Available in coaxial or
RJ45 connector variants. Coaxial variants are not supported on an IP500
carrier card.
Dual PRI Trunk Cards
As the single PRI cards above but supporting the connection of two PRI trunks.
On the IP406 V2, supported in Slot A only.
IP500/IP500 V2 Installation
IP Office 8.0
244
external expansion modules.
251
external expansion modules.
251
244
245
245
246
245
243
System Overview: Control Unit Cards
IP500 Legacy Card Carrier
IP500
Analog
Analog
15-601042 Issue 25i (03 January 2013)
218
IP500
V2
Page 25