Mac Information Configuration Commands; Mac-Address Information Enable (Ethernet Interface View); Mac-Address Information Enable (System View) - HP A5830 Series Command Reference Manual

MAC Information configuration commands

MAC Information applies only to Layer 2 Ethernet interfaces.

mac-address information enable (Ethernet interface view)

Description
Use the mac-address information enable command to enable MAC Information on the Layer 2 Ethernet
interface.
Use the undo mac-address information enable command to disable MAC Information on the Layer 2
Ethernet interface.
By default, MAC Information is disabled on a Layer 2 Ethernet interface.
This command is not supported on aggregate interfaces.
To enable MAC Information on an Ethernet interface, enable MAC Information globally.
Syntax
mac-address information enable { added | deleted }
undo mac-address information enable { added | deleted }
View
Layer 2 Ethernet interface view
Default level
1: Monitor level
Parameters
added: Enables the device to record security information when a new MAC address is learned on the
Ethernet port.
deleted: Enables the device to record security information when an existing MAC address is deleted.
Example
# Enable MAC Information on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mac-address information enable added

mac-address information enable (system view)

Description
Use the mac-address information enable command to enable MAC Information globally.
Use the undo mac-address information enable command to disable MAC Information globally.
By default, MAC Information is disabled globally.
58