Configuring Many-To-One Vlan Mapping - HP A3100-8 v2 SI Configuration Manual

To do...
Associate the class with the
behavior to map the SVLAN to the
CVLAN
Configuring the customer-side port
Follow these steps to configure the customer-side port:
To do...
Enter system view
Enter Layer 2 Ethernet interface
view
Configure the port as a trunk port
Assign the port to CVLANs and
SVLANs
Apply the uplink policy to the
incoming traffic
Apply the downlink policy to the
outgoing traffic
Configuring the network-side port
Follow these steps to configure the network-side port:
To do...
Enter system view
Enter Layer 2 Ethernet interface
view
Configure the port as a trunk port
Assign the port to SVLANs

Configuring many-to-one VLAN mapping

Perform many-to-one VLAN mapping on the wire-closet switch (see
traffic from the same customer in one VLAN.
Perform these tasks to configure many-to-one VLAN mapping:
Use the command...
classifier tcl-name behavior behavior-name
Use the command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan { vlan-id-list
| all }
qos apply policy policy-name
inbound
qos apply policy policy-name
outbound
Use the command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan { vlan-id-list
| all }
158
Remarks
Required
Remarks
—
—
Required
The default link type of an Ethernet
port is access.
Required
By default, a trunk port belongs to
VLAN 1 only.
Required
Required
Remarks
—
—
Required
The default link type of ports is
access.
Required
By default, a trunk port belongs to
VLAN 1 only.
Figure 49) to transmit all types of