Configuring The Tpid Value In Vlan Tags; Qinq Configuration Examples; Basic Qinq Configuration Example - HP 3100 Series Configuration Manual

Configuring the TPID value in VLAN tags

Step
Enter system view.
1.
Configure the TPID value.
2.

QinQ configuration examples

Basic QinQ configuration example

Network requirements
As shown in
•
The two branches of Company A, Site 1 and Site 2, are connected through the service provider
network and use CVLANs 10 through 70. The two branches of Company B, Site 3 and Site 4,
are connected through the service provider network and use CVLANs 30 through 90.
•
PE 1 and PE 2 are edge devices on the service provider network and are connected through
third-party devices with a TPID value of 0x8200.
Configure the edge and third-party devices to enable communication between the branches of
Company A through SVLAN 100, and communication between the branches of Company B through
SVLAN 200.
Figure 52 Network diagram
Configuration procedure
Command
system-view
qinq ethernet-type hex-value
Figure 52:
Remarks
N/A
Optional.
By default, the TPID value is 0x8100.
The configuration applies to all ports.
155