Port-Based Multicast Vlan Configuration Example - HP A5500 SI Switch Series Configuration Manual

Host port(s):total 1 port(s).
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
Vlan(id):4.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 0 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Host port(s):total 1 port(s).
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
Vlan(id):10.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Host port(s):total 0 port(s).
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 0 port(s).
The output shows that MLD snooping is maintaining the router port in the IPv6 multicast VLAN—VLAN
10—and the member ports in the sub-VLANs—VLAN 2 through VLAN 4.

Port-based multicast VLAN configuration example

Network requirements
As shown in
•
GigabitEthernet 1/0/1 and to Switch A through GigabitEthernet 1/0/2.
MLDv1 runs on Router A. MLDv1 snooping runs on Switch A. Router A acts as the MLD querier.
•
Switch A's GigabitEthernet 1/0/1 belongs to VLAN 10, GigabitEthernet 1/0/2 through
•
GigabitEthernet 1/0/4 belong to VLAN 2 through VLAN 4 respectively, and Host A through Host
C are attached to GigabitEthernet 1/0/2 through GigabitEthernet 1/0/4 of Switch A.
The IPv6 multicast source sends IPv6 multicast data to IPv6 multicast group FF1E::101. Host A, Host
•
B, and Host C are receivers of the IPv6 multicast group.
GE1/0/3
GE1/0/3
GE1/0/4
GE1/0/4
GE1/0/1
Figure 75, Router A connects to an IPv6 multicast source—Source—through
(D)
(D)
(D)
288