Network - FLIR Quasar Gen III User And Installation Manual

9.3.3

Network

From the System screen, click the Network tab. The following screens are available:
Basic QoS
9.3.3.1 Basic
The Basic screen is used to configure the camera's basic network settings.
It is possible to connect to the camera with either fixed or dynamic (DHCP) IP address. The camera also
provides PPPoE (Point-to-Point Protocol over Ethernet) support for users who connect to the network via
PPPoE.
The Basic screen is divided into three sections: General, Advanced and IPv6 Configuration.
General
Select one of the following options in the General area for configuring network settings:
·
Get IP address automatically
·
Use fixed IP address
·
User PPPoE
September 7, 2017
SNMP UPnP
Network > Basic Screen
CP-6302 User and Installation Guide
DDNS Mail
Configuration and Operation
FTP HTTP
43