Schedule - FLIR Quasar Gen III User And Installation Manual

Triggered Action
The Administrator can specify various alarm actions to take when an alarm is triggered. See the
for a detailed description of the actions. The following options are available:
·
Enable alarm output 1 – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when motion is detected.
·
Enable alarm output 2 – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when motion is detected.
·
Send alarm message by FTP – Select whether to send an alarm message by FTP when motion is
detected.
·
Send alarm message by E-Mail – Select whether to send an alarm message by e-mail when
motion is detected.
·
Upload image by FTP – Select this box in order to upload an image to a designated FTP site when
motion is detected according to various parameters.
·
Upload image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters.
·
Send HTTP notification – Check this box to send a notification by HTTP.
·
Record video clip – Select this box in order to save the alarm-triggered recording to your
microSDXC card.
File Name
The uploaded image's filename format is set in this section. Select one that meets your requirements.
Click SAVE to save the motion detection settings.
9.3.7

Schedule

The Schedule screen is used for setting schedules for the network failure detection and motion detection
functions. The functions in this tab allow administrators to create customized schedules for the camera
that uses this option. If a schedule exists, the administrator can apply that schedule to this camera using
the available drop-down list. See figure below.
To access the schedule function, open the Main window, select the System tab, and click the Schedule
tab.
September 7, 2017
Schedule Screen
CP-6302 User and Installation Guide
Configuration and Operation
IO section
69