Alarm Input/Output Pin-Out; Connecting The Unit To The Network - FLIR CF-5212 User And Installation Manual

Introduction to the CF-5212/CF-5222 IP Fixed Camera
ID Connector Name
1 Line Out
2 Line In/Mic In
3
Network/PoE
4 Video
5 SD
DC 12V/AC 24V
6
7
to I/O 1-7
9
Auto Iris
10
11
12

Alarm Input/Output Pin-out

The alarm input and output connections are shown below

3.3 Connecting the Unit to the Network

A Cat 5 Ethernet cable is recommended for network connection. For best transmission quality, the cable
length should not exceed 100 meters (328 feet). Connect one end of the Ethernet cable to the
Network/PoE port on the connector panel and plug the other end into the network switch or PC. Check
the status of the link and activity LEDs. The LEDs on the Network/PoE port illuminate green (indicating a
stable network connection) or flashing yellow (to indicate network activity). If the LEDs are unlit, check
the LAN connection.
12
Pin Number/
Connector Type
RJ45, Network LEDs
BNC
1 – Power (+)
2 – Reserved
3 – GND (-)
1- Power (+)
2- Earth GND
3- Power (-)
1 - Output (+)
2 - Output (-)
3 - Input (+)
4 - Input (-)
5 – GND
6 - D (-)
7 - D (+)
DC iris lens connector
N/A
N/A
Pin No. Designation
1 Output (+)
2 Output (-)
3 Input (+)
4 Input (-)
CF-5212/CF-5222 User and Installation Guide
Definition Description
Audio out
2-way audio transmission
Audio in
10/100 Mbps Power over Ethernet
Ethernet/PoE and Network Port
Analog video Connect video coax cable
microSD card slot Not supported
12V DC
3-pin power terminal block
24V AC
Alarm output
Alarm input
7-pin I/O terminal block
Grounding
Reserved
Do NOT connect
DC iris port Connect cable from lens
Power indication (Green
Power LED
LED indicates Power On)
Reset Resets full factory defaults
.
Terminal Block
Alarm Connections
April 25, 2017