FLIR Quasar Gen III User And Installation Manual page 61

In the Image Frequency text box, from the drop-down list select the number of frames per
seconds from 1-15 for the upload.
Note:
Make sure that SMTP configuration has been completed. See
·
Send HTTP notification – Select this checkbox to send a notification by HTTP. Select the
destination HTTP address from the drop-down menu and specify the parameters for event
notifications by the IO event triggered. When an alarm is triggered, the notification will be sent to
one of two specified HTTP servers. See figure below.
·
Record video clip – Select this box in order to save the alarm-triggered recording to your
microSDXC card or to the NAS. Enter the number of seconds for the pre-trigger buffer. Select the
first radial button if you wish to upload for a specified length of time and enter the number of
seconds. Alternatively, select the second radial button to upload while the trigger is active.
Note:
In order to use this function, make sure that local recording with a microSDXC card is activated
and that the NAS is properly configured. See
·
PTZ Function – Select this checkbox to set a Preset, Sequence, Auto Pan, or Pattern; Function
line; or Dwell time. These functions can be configured in more detail from the
Click SAVE after configuring the settings.
September 7, 2017
Send HTTP Notification Settings
Record Video Clip Settings
Recording
PTZ Function Settings
CP-6302 User and Installation Guide
Configuration and Operation
Mail for details.
for further details.
Settings > PTZ tab.
55