FLIR Quasar Gen III User And Installation Manual page 67

Triggered Action
The Administrator can specify various alarm actions to take when an alarm is triggered. See the
for a detailed description of the actions. The following options are available:
·
Enable alarm output 1 – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when a network failure is detected.
·
Enable alarm output 2 – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when a network failure is detected.
·
Send message by FTP – Select whether to send an alarm message by FTP when a network
failure is detected.
·
Send message by E-Mail – Select whether to send an alarm message by e-mail when an audio
event is detected.
·
Upload Image by FTP – Selecting this option enables you to assign an FTP site and configure
various parameters.
·
Upload image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters.
·
Send HTTP notification – Select this checkbox to send a notification by HTTP.
·
Record video clip – Select this box in order to save the alarm-triggered recording to your
microSD/SDXC card or to the NAS.
Click SAVE after configuring the settings.
File Name
·
File Name – Enter a file name in the field, for example image.jpg. The uploaded image's file name
format is set in this section. Select one that meets your requirements.
·
Add date/time suffix (default setting)
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
·
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
·
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix ends at the number being set. For example, if the setting is up to "10," the file
name will start from 00, end at 10, and then start over again.
·
Overwrite
The original image in the FTP site will be overwritten by the new uploaded file with a static
filename.
Click SAVE after configuring the settings.
September 7, 2017
CP-6302 User and Installation Guide
Configuration and Operation
IO section
61