Camera Tab - FLIR Quasar Gen III User And Installation Manual

Server Gain Setting
Set the audio input/output gain levels for sound amplification. The sound will be turned off if the input or
output gain is set to Mute.
·
The audio input gain is adjustable from 1-10. The default setting is 3.
·
The audio output gain is adjustable from 1-6. The default setting is 3.
Bit Rate
Selectable audio transmission bit rate include 16 kbps (G.726), 24 kbps (G.726), 32 kbps (G.726), 40 kbps
(G.726), µ-law (G.711), a-law (G.711), AAC, PCM (128 kbps), PCM (256 kbps), PCM (384 kbps), and PCM
(768 kbps). Both µLAW and ALAW signify 64 kbps, but in different compression formats. A higher bit rate
enables higher audio quality, but requires higher bandwidth. The default setting is uLAW.
Note:
Latitude does not support G.726.
Click SAVE to confirm the settings.
Recording to Storage
This function enables recording of the audio on the SD card and NAS. The Recording to Storage function
may be enabled or disabled in the Audio screen. The default setting is Disable.
Note:
This function works only if the Recording to Storage option has been selected or if the Schedule option
has been set.
Click SAVE to confirm the settings.
9.6

Camera Tab

From the Camera tab, the administrator can adjust camera settings from the following tabs:
Exposure Picture Adjustment
September 7, 2017
Advanced Picture Settings
Camera Section Tabs
CP-6302 User and Installation Guide
Configuration and Operation
IR Function Misc.
97