Reference Manual
00809-0100-4100, Rev AA
Figure 1-3. Block diagram of operation
A
Signal Processing
Sensor Module
Temp.
Memory
Sensor
A. Sensor Module
B. Electronics Board
C. WirelessHART Signal to Control System
D. Field Communicator
1.5
Considerations before transmitter installation
1.5.1
Wireless considerations
Power up sequence
The Smart Wireless Gateway (Gateway) should be installed and functioning properly before any
wireless devices are powered. Install the power module, SmartPower Solutions, model number
701PGNKF green power module, into the 3051 to power the device. This results in a simpler and
faster network installation. Enabling Active Advertising on the Gateway ensures that new
devices are able to join the network faster. For more information see the Smart Wireless
Gateway Reference Manual (Document No. 00809-0200-4420).
Antenna position
The antenna is internal to the pressure transmitter. To achieve optimal range, orient the
transmitter with the sensor horizontal and the power module closest to the ground as shown in
Figure
Introduction
Microprocessor
Sensor linearization
Rerange
Damping
Diagnostics
Engineering units
Communication
Memory
Configuration
X-X. Good connectivity can also be achieved in other orientations. The antenna should
B
Digital-to-
Analog Signal
Conversion
WirelessHART
Communication
Section 1: Introduction
June 2012
C
D
5