Safety Messages; Warnings () - Emerson Rosemount 2051 Wireless Series Reference Manual

Reference Manual
00809-0100-4100, Rev AA
Section 4
Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 47
Network Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 48
Verify Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 48
4.1

Safety Messages

Instructions and procedures in this section may require special precautions to ensure the safety
of the personnel performing the operations. Information that potentially raises safety issues is
indicated by a warning symbol ( ). Please refer to the following safety messages before
performing an operation preceded by this symbol.
4.1.1 Warnings ( )
Failure to follow these installation guidelines could result in death or
serious injury.

Explosions could result in death or serious injury.


Process leaks could result in death or serious injury.


Electrical shock could cause death or serious injury.

Note
The Rosemount 3051 Wireless and all other wireless devices should be installed only after the
Smart Wireless Gateway has been installed and is functioning properly.
Wireless devices should also be powered up in order of proximity from the Smart Wireless
Gateway, beginning with the closest device to the Smart Wireless GatewaySmart. This will result
in a simpler and faster network installation.
Commissioning
Commissioning
Make sure only qualified personnel perform the installation.
Before connecting a Field Communicator in an explosive atmosphere, make sure the
instruments are installed in accordance with intrinsically safe or non-incendive field
wiring practices.
Verify that the operating atmosphere of the transmitter is consistent with the
appropriate hazardous locations certifications.
Install and tighten process connectors before applying pressure.
Do not attempt to loosen or remove process connectors while the transmitter is in
service.
Avoid contact with the leads and terminals. High voltage that may be present on leads
can cause electrical shock.
Section 4: Commissioning
June 2012
47