Standard Configuration - Emerson Rosemount 2051 Wireless Series Reference Manual

Appendix A: Specifications and Reference Data
June 2012
A.6 Options

Standard configuration

Unless otherwise specified, transmitter is shipped as follows:
Engineering units
Differential/Gage:
Absolute/3051TA:
Low Limit:
High Limit:
Output:
Flange type:
Flange material:
O-ring material:
Drain/vent:
LCD Display:
Alarm:
Software tag:
Custom configuration
If Option Code C1 is ordered, the customer may specify the following data in addition to the
standard configuration parameters.





Refer to the "Rosemount Enhanced 3051 Configuration Data Sheet" document number
00806-0100-4007.
Tagging (3 options available)



Optional Rosemount 304, 305, or 306 Integral Manifolds
Factory assembled to 3051C and 3051T transmitters. Refer to the following Product Data Sheet
(document number 00813-0100-4839 for Rosemount 304 and 00813-0100-4733 for
Rosemount 305 and 306) for additional information.
126
inH O (Range 0, 1, 2, and 3)
2
psi (Range 4 and 5)
psi (all ranges)
0 (engineering units above)
Upper range limit
Linear
Specified model code option
Specified model code option
Specified model code option
Specified model code option
Installed or none
High
(Blank)
Output Information
Transmitter Information
LCD Display Configuration
Hardware Selectable Information
Signal Selection
Standard SST hardware tag is wired to the transmitter. Tag character height is 0.125 in.
(3,18 mm), 56 characters maximum.
Tag may be permanently stamped on transmitter nameplate upon request, 56
characters maximum.
Tag may be stored in transmitter memory. Character limit is dependent on protocol.
–- WirelessHART: 32 characters
Reference Manual
00809-0100-4100, Rev AA
Specifications and Reference Data