Reference Manual
00809-0100-4100, Rev AA
3.4.5
Power Module Installation
Figure 3-4. Power Module
A. Housing rotation screw (5/64-inch hex wrench required)
To make connections, perform the following procedure:
1.
2.
3.
3.4.6
Installing the LCD Display
Transmitters ordered with the LCD display will be shipped with the display installed.
Note
Only use Rosemount Wireless LCD Part Number: 00753-9004-0002
Note
An LCD from a wired device will not function in a wireless device.
In addition to housing rotation, the optional LCD display can be rotated in 90-degree increments
by squeezing the two tabs, pulling out, rotating and snapping back into place.
If LCD pins are inadvertently removed from the interface board, carefully re-insert the pins
before snapping the LCD display back into place.
Use the following procedure and
Installation
Remove the housing cover on the Power Module compartment side. The Power Module
supplies all power to the transmitter.
Connect Power Module 701PGNKF.
Replace the Power Module cover and tighten to safety specification (metal to metal).
A
Figure 3-5
to install the LCD display:
Section 3: Installation
June 2012
37