Registration; To Configure Pppoe Via Phone User Interface - Yealink SIP-T40P User Manual

4. Enter the desired value in the IP v6 IP, IPv6 IP Prefix, IP v6 Default Gateway, IP v6
P ri.DNS and IP v6 Sec.DNS fields respectively.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a PPP negotiation
to obtain the IP address. Contact your system administrator for the PPPoE user name
and password.

To configure PPPoE via phone user interface:

1. Press Me nu->Settings->Advanced Settings (default password: admin)
->Ne twork->WAN Port.
2. Press
3. Press
4. Enter the user name and password in the corresponding fields.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Not e Wrong network settings may re sul t in inaccessi bility o f yo ur phone an d may al so have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. The SIP-T40P IP
phone supports up to 3 accounts. If your phone is not registered, you may have to
register it. For more information on how to register your phone, refer to
Management
to select IP v 4 and then press the Ent er soft key.
to select P P PoE IPv4 Client and then press the Ent er soft key.
on page 60.
Getting Started
Account
19