Registering The Handset; Possible Reasons For Registration Failure; Registering A Handset To The Dect Manage - Yealink W90B User Manual

Task
Delete one or more
characters
Note: 2aB is only applicable to the DD phone.

Registering the Handset

You need to register your handset to the DECT manager (DM) if you want to use the basic functions of the
DECT multi-cell system.
•

Possible Reasons for Registration Failure

•

Registering a Handset to the DECT Manage

• Selecting a System to Connect
Possible Reasons for Registration Failure
Some scenarios may cause registration failure.
• Incorrect base PIN (check with your system administrator).
• Base station is out of range.
• Base station is not in registration mode.
Note: If registration was not successful, the handset screen will prompt you that the registration is
failed.
Registering a Handset to the DECT Manage
Procedure
1. On the web user interface, go to Handset & Account > Handset Registration.
2. Click Add Handset.
3. Click Start Register Handset to set the DM to the registration mode.
4. On the handset, do one of the following:
Press the Reg soft key on the handset to register quickly.
•
Press OK > Register Handset and then select the desired base to register the handset.
•
• Press OK > Settings > Registration > Register Handset and then select the desired base to
register the handset.
You need to enter the base PIN (default: 0000) after a base is found.
After the handset is registered successfully, the handset LCD screen prompts "Handset Subscribed".
Note: You can also register groups of handsets in the registration center via Handset &
Account > Registration Center.
Action
On the DD phone, position the cursor to the right of the character, and
select the Delete soft key.
On the CP930W, press the Delete soft key.
| Registering the Handset | 24