ADT DVR7800S-U Series User Manual page 246

Hybrid Standalone DVR User Guide
PTZ Type
There are two options: Local or Remote. Select the Remote type if you are connecting to the network
PTZ.
Protocol
Select the corresponding dome protocol such as PELCO D.
Address
Set the corresponding PTZ camera address. The default value is 1.
Note that your setup here must comply with your PTZ camera address.
Baud Rate
Select the dome baud rate. Default setup is 9600.
Data Bit
Default setup is 8. Set this according to the PTZ camera dial switch setup.
Stop bit
Default setup is 1. Set this according to the PTZ camera dial switch setup.
Parity
Default setup is none. Set this according to the dial switch setup on the PTZ camera.
4.7.6.6 Text Overlay
The Text Overlay (aka ATM/POS) function is for financial areas. It includes Sniffer, information
analysis and title overlay function. The Sniffer mode includes Com and Network.
COM Mode
Select the NET Sniffer Mode when using the network connection on the rear of the DVR for the
overlay. The following describes the various entries in the NET mode screen, which varies depending
on the protocol used. Make your selections as described below and then click Save.
Protocol
Select POS or NONE. The dialog changes depending on the selection you make here.
DVR7800S-U Series Hybrid DVR User Guide
Figure 4-95
4 Web Service
236