Table of Contents
Advertisement
Hybrid Standalone DVR User Guide
3.7.5 Pan/Tilt/Zoom (PTZ)
This section describes how to set up and control your pan/tilt/zoom (PTZ) camera(s).
Note: All the operations here are based on Pelco D protocol. For other protocols, there might be
differences.
3.7.5.1 Cable Connection
Follow the procedures below to go on cable connection:
1. Connect the dome RS485 port to DVR 485 port.
2. Connect the dome video output cable to DVR video input port.
3. Connect the power adapter to the dome.
3.7.5.2 PTZ Setup
Before setup, verify the following connections:
•
Pan/Tilt/Zoom (PTZ) and decoder connections are correct
•
Decoder address setup is correct
•
Decoder A (B) line connects with the DVR A (B) line
1. In the Main Menu, click Setting and then Pan/Tilt/Zoom. The PTZ dialog opens.
2. Complete the setup as follows:
DVR7800S-U Series Hybrid DVR User Guide
Figure 3-75
3 Local Menu Operations
119
Advertisement
Table of Contents
