ADT DVR7800S-U Series User Manual page 139

Hybrid Standalone DVR User Guide
3.7.6.2 Net Mode
Use the Net mode if you are using a network to connect to the device. The interface is generally the
same as the COM mode. The protocol depends on your self-developed protocol. The setup may vary
since the connected device or the protocol is not the same.
To setup Text Overlay in Network Mode with the ATM/POS protocol:
1. Select the Net tab.
2. For Protocol, select ATM/POS from the dropdown menu.
3. Set the Source IP, Destination IP and Record Channels.
Source IP refers to host IP address that sends out information, which is usually the device
host. The Destination IP refers to other systems that receive the information.
Note:
•
Usually you will not need to set the source port and target port.
•
There are four IP groups. The Record Channel applies only to one group (optional).
4. For the Frame ID groups, click the Data button to open the dialog shown in Figure 3-91.
DVR7800S-U Series Hybrid DVR User Guide
Figure 3-90
3 Local Menu Operations
129