ADT DVR7800S-U Series User Manual page 106

Hybrid Standalone DVR User Guide
Delay
To avoid rerecording the same event, enter the number of seconds to wait after the event has ended
before a new recording can begin. This value ranges from 10s to 300s.
Tour
Enable the tour function to present an alternating display (much like a slideshow) of the channel(s)
you have set to record when a motion detect event occurs. The system supports 1/8-window tour.
Refer to section 3.7.2.2 TV Adjust Tab on page 114 for tour interval setup. However, the alarm tour
has higher priority than the tour setup you set in the Display screen.
Snapshot
Enable this function to take a snapshot image on the designated channel when an alarm occurs:
1. Go to Setting > Camera > Encode. Select Snapshot as the activation mode, and then set
corresponding parameters.
2. Go to Setting > Network > FTP. Set the FTP server information and the picture upload interval.
Enable the FTP function and click Save.
3. Go to Setting > Event > Alarm. Select the corresponding channel, then enable the snapshot
function.
Note: Activation Snapshot has higher priority than Schedule Snapshot.
Video Matrix
Check the box to enable this function. When an event occurs, the device connected to the SPOT OUT
port on the rear of the DVR displays video output from the selected channel in a 1-window tour. See
3.7.3 Video Matrix on page 117 for details on how to set up Video Matrix.
DVR7800S-U Series Hybrid DVR User Guide
Figure 3-53
3 Local Menu Operations
96