ADT DVR7800S-U Series User Manual page 221

Hybrid Standalone DVR User Guide
Tour
Enable the tour function to present an alternating display (much like a slideshow) of the channel(s)
you have set to record when a motion detect event occurs. The system supports 1/8-window tour.
Refer to Tour Tab on page 228 for tour interval setup. However, the alarm tour has higher priority
than the tour setup you set in the Display screen.
Snapshot
When an alarm occurs, this feature takes a still image of the channel(s) you set to record.
Check the box to enable, and the click the buttons for the channels that you want included in the
snapshot. The selected channels are highlighted.
Video Matrix
Check the box to enable this function. When an event occurs, the device connected to the SPOT OUT
port on the rear of the DVR displays video output from the selected channel in a 1-window tour.
Audio Out File
Similar to Voice Prompts on the local menu, enable this function to sound when the event occurs,
and then select the audio file to play.
Checkboxes
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Alarm Upload. If enabled, the alarm signal is uploaded to the network.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when a motion detection event
occurs. Note: This feature is not supported by ADT.
Log. If enabled, a log is created for the event.
DVR7800S-U Series Hybrid DVR User Guide
4 Web Service
211