Figure 3-132: End Process Wizard - AudioCodes Mediant 600 User Manual

6. Click the Next
now perform one of the following:
•
Load a new ini file: Click Browse, navigate to the ini file, and then click Send
File; the ini file is loaded to the device and you're notified as to a successful
loading.
•
Retain the existing configuration (ini file): Do not select an ini file, and ensure that
the 'Use existing configuration' check box is selected (default).
•
Return the device's configuration settings to factory defaults: Do not select an ini
file, and clear the 'Use existing configuration' check box.
7. Click the Next
desired auxiliary files. To return to the previous wizard page, click the Back
button. As you navigate between wizard pages, the relevant file type corresponding to
the Wizard page is highlighted in the left pane.
8. When you have completed loading all the desired files, click the Next
until the last wizard page appears ("FINISH" is highlighted in the left pane).
9. Click the Reset
newly loaded files to flash memory and then resets the device.
Note:
After the device resets, the 'End Process' screen appears displaying the burned
configuration files:
10. Click End Process to close the wizard; the Web Login dialog box appears.
11. Enter your login user name and password, and then click OK; a message box appears
informing you of the new cmp file.
12. Click OK; the Web interface becomes active, reflecting the upgraded device.
SIP User's Manual
button; the wizard page for loading an ini file appears. You can
button to progress to the relevant wizard pages for loading the
button to complete the upgrade process; the device 'burns' the
Device reset may take a few minutes (depending on cmp file version, this
may even take up to 30 minutes).
Figure 3-132: End Process Wizard Page
206
Mediant 600 & Mediant 1000
button
Document #: LTRT-83308