Figure 3-115: Caller Display Information Page - AudioCodes Mediant 600 User Manual

3.3.2.11.5.7 Configuring Caller Display Information
The 'Caller Display Information' page allows you to enable the device to send Caller ID
information to IP when a call is made. The called party can use this information for caller
identification. The information configured on this page is sent in an INVITE message in the
From header. For information on Caller ID restriction according to destination/source
prefixes, see ''Configuring Number Manipulation Tables'' on page 146.

To configure the Caller Display Information:
1. Open the 'Caller Display Information' page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Analog Gateway submenu > Caller Display Information).
2. In the 'Caller ID/Name' field corresponding to the desired port, enter the Caller ID
string (up to 18 characters).
3. From the 'Presentation' drop-down list, select one of the following:
•
'Allowed' [0] - sends the string defined in the 'Caller ID/Name' field when a Tel-to-
IP call is made using the corresponding device port.
•
'Restricted' [1] - the string defined in the 'Caller ID/Name' field is not sent.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 197.
Notes:
SIP User's Manual

Figure 3-115: Caller Display Information Page

•
When FXS ports receive 'Private' or 'Anonymous' strings in the From
header, they don't send the calling name or number to the Caller ID
display.
•
If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is
used instead of the Caller ID name defined on this page.
•
When the 'Presentation' field is set to 'Restricted', the Caller ID is sent to
the remote side using only the P-Asserted-Identity and P-Preferred-
Identity headers (AssertedIdMode).
•
The value of the 'Presentation' field can be overridden by configuring the
'Presentation' field in the 'Source Number Manipulation' table (see
''Configuring Number Manipulation Tables'' on page 146).
•
You can also configure the Caller Display Information table using the ini
file table parameter CallerDisplayInfo.
180
Mediant 600 & Mediant 1000
Document #: LTRT-83308