SIP User's Manual
To add Proxy servers:
1.
Open the 'Proxy Sets Table' page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
2.
From the 'Proxy Set ID' drop-down list, select an ID for the desired group.
3.
Configure the Proxy parameters according to the following table.
4.
Click the Submit button to save your changes.
5.
To save the changes to flash memory, see ''Saving Configuration'' on page 197.
Parameter
Web: Proxy Set ID
EMS: Index
[ProxySet_Index]
Version 6.2
Figure 3-83: Proxy Sets Table Page
Table 3-22: Proxy Sets Table Parameters
The Proxy Set identification number.
The valid range is 0 to 31. The Proxy Set ID 0 is used as the
default Proxy Set.
Note: Although not recommended, you can use both default
Proxy Set (ID 0) and IP Groups for call routing. For example, on
the 'Trunk Group Settings' page (see ''Configuring Trunk Group
Settings'' on page 142) you can configure a Serving IP Group to
where you want to route specific Trunk Group's channels, while
all other device channels use the default Proxy Set. At the
same, you can also use IP Groups in the 'Outbound IP Routing
Table' (see ''Configuring the Outbound IP Routing Table'' on
page 159) to configure the default Proxy Set if the parameter
PreferRouteTable is set to 1.
To summarize, if the default Proxy Set is used, the INVITE
121
3. Web-Based Management
Description
February 2011