CLUTCH
Place the master cylinder on the handlebar and
install the holder and the two mounting bolts.
Aligh the end of the holder with the punch mark on
the handlebar.
Tighten the top bolt first them the bottom bolt.
TORQUE: 10-14 N·m (1.0-1.4 kg-m, 7-10 ft·lb)
Install the oil hose with the bolt and its two sealing
washers.
Install the push rod end piece into the clutch lever
hole and install the clutch lever.
Connect the clutch switch wires to the switch
terminals.
Fill the reservoir and bleed the clutch system
(page 7·4).
CLUTCH SLAVE CYLINDER
DISASSEMB LY
Remove the left crankcase rear cover.
Remove the left crankcase rear cover bracket.
Place a container under the slave cylinder, remove
the oil bolt and disconnect the clutch hose.
NOTE:
Avoid spilling clutch fluid on painted sur·
faces.
Remove the slave cylinder.
r;j)
V65MAGNA
CLUTCH HOSE
PUNCH MARl<
CRANI<CASE REAR COVER
SLAVE CYLINDER
-8
98
OIL BOLT
CRANI<CASE REAR
COVER BRACI<ET
Date of Issue: Dec, 1982
© HONDA MOTOR CO., LTD.