Clutch Di'sassembly - Honda V65 MAGNA Shop Manual

~
V65MAGNA
STARTER DRIVEN GEAR INSPECTION
Inspect the driven gear for damage or excessive
wear.
Measure the driven gear O.D.
SERVICE LIMIT: 54.16 mm (2.132 in)
CLUTCH DI'SASSEMBLY
NOTE:
Do not operate the clutch lever after removing
the clutch. To do so will cause difficulty in
reassembling the clutch.
Remove the snap ring, lifter plate, lifter guide,
release bearing and lifter rod.
LIFTER PLATE
CLUTCH
Install the rear brake pedal.
Shift the transmission into high gear and apply the
rear brake.
NOTE:
When the engine is not in the frame, shift the
transmission into gear and use the MAIN-
SHAFT HOLDER, PIN 07923-6890100, to
hold the final shaft.
Remove the lock nut and lock washer.
Remove the clutch spring set plate, clutch spring
and washer.
LIFTER GUIDE
CLUTCH SPRING
RELEASE BEARING
SPRING SET PLATE
Date of Issue: Dec, 1982
© HONDA MOTOR CO., LTD.
LOCK NUT WRENCH
07916-4220000
103 -13