Installation - Honda V65 MAGNA Shop Manual

FRONT WHEEL/SUSPENSION
V65MAGNA
Remove the bolt caps and the handlebar cover.
Remove the handlebar upper holder bolts.
Remove the handlebar upper holders and the center
handlebar.
UPPER HOLDERS
HANDLEBAR COVER CENTER HANDLEBAR
INSTALLATION
Place the center handlebar onto the lower holder,
aligning its punch mark with the upper surface of
the lower holder.
Place the upper holder onto the lower holder with
its punch mark facing forward.
Tighten the forward bolts first, then tighten the
rear bolts.
TORQUE: 40-50 N·m (4.0-5.0 kg·m, 29-36 ft·lb)
Install the bolt caps and handlebar cover.
PUNCH MARKS
HANDLEBAR COVER PUNCH MARK
Install the right and left handlebars into the center
handlebar.
Install the handlebar set screws.
Apply grease to the handlebar pinch bolts.
Tighten the pinch bolts after aligning the punch
marks with the slits on the center handlebar.
TORQUE: 25-30 N·m (2.5-3.0 kg·m, 18-22 ft·lb)
SET SCREW
15-12
236
Dec, 1982
©
HONDA MOTOR CO., LTD.