Honda V65 MAGNA Shop Manual page 178

~HOND.A
~
V65MAGNA
Coat the rod small end with molybdenum disulfide
grease.
Assemble the pistons and connecting rods with the
pistons and piston clips as follows.
Front cylinder connecting rod and piston assembly.
Note that the front cylinder connecting rods are
marked MB4-F.
Install the pistons on the front connecting rods so'
that the intake "IN" mark is facing opposite the oil
hole in the rod.
Rear cylinder connecting rod and piston assembly ..
Note that the rear cylinder connecting rods are
marked MB4-R.
Install the pistons on the rear rods so that the intake
"IN" mark is facing the same direction as the oil
hole in the rod.
NOTE:
• Do not interchange the pistons, piston
pins or connecting rods.
Make sure that the piston pin clips are
properly seated.
FRONT CYLINDER
"IN" MARK
REAR CYLINDER
OIL HOLE
CRANKSHAFT/PISTON
"MB4-F" MARK
OIL HOLE
"MB4-R" MAR K
"IN" MARK
Align the hole in the connecting rod bearing insert
with the hole in the connecting rod and install the
insert.
OIL HOLES
Date of Issue: Dec, 1982
© HONDA MOTOR CO., LTD.
177
12-13