Brake Pad Wear; Brake System; Brake Pedal Height - Honda V65 MAGNA Shop Manual

MAINTENANCE
BRAKE PAD WEAR
Check the brake pads for wear by looking through
the slot indicated by the arrow cast on the caliper
assembly.
Replace the brake pads if the wear Iine on the pads
reaches the edge of the brake disc (page 17-5).
CAUTION:
Always replace the brake pads in pairs to
assure even disc pressure.
V65MAGNA
BRAKE SYSTEM
Inspect the brake hoses and fittings for deterio-
ration, cracks and signs of leakage. Tighten any
loose fittings.
Replace hoses and fittings as required.
BRAKE DISC
BRAKE DISC
ARROW
ARROW
BRAKE PADS
\ "III!
BRAKE PEDAL HEIGHT
Adjust brake pedal height so the pedal is 7 mm (1/4
in) below the top of the foot peg.
CAUTION:
Incorrect brake pedal height can cause brake
drag.
To Adjust:
Loosen the stopper bolt lock nut and turn the
stopper bolt.
Retighten the lock nut.
NOTE:
After adjusting the brake pedal height, check
the rear brake light switch and brake pedal
free play and adjust if necessary.
LOCK NUT
STOPPER BOLT
3-14
42
Date of Issue: Dec,1982
©
HONDA MOTOR CO./LTD.