Cable & Harness Routing - Honda V65 MAGNA Shop Manual

~HON'DA.
~ V65MAGNA
GENERAL INFORMATION
x
IS
o
• Do not squeeze wires against the weld or end of
its clamp when a weld-on clamp is used.
CABLE & HARNESS ROUTING
Note the following when routing cables and wire
harnesses.
A loose wire, harness or cable can be safety hazard.
After clamping, check each wire to be sure it is
·secure.
• Secure wires and wire harnesses to the frame
with their respective wire bands at the designated
locations. Tighten the bands so that only the
insulated surfaces contact the wires or wire
harnesses.
• Route harnesses so they are not pulled that or
have excessive slack.
o
~
x
~
• Do not use wires or harnesses with a broken
insulator. Repair by wrapping them with a pro-
tective tape or replace them.
• Protect wires and harnesses with electrical tape
or tube if they are contact a sharp edge or
corner. Clean the attaching surface thoroughly
before applying tape.
sharp edges or 1Il
Route wire
corners.
1Il
Also avoid
screws.
of bolts and
frqm the exhaust pipes
1Il
Be sure
properly.
are seated in their grooves
1Il
After Clamping, cHeck each harness to be certain
that it is not interferring with any moving or
sliding parts.
• After routing, check that the wire harnesses are
not twisted or kinked.
CIt
Wire harnesses routed along the handlebars
should not be pulled taut, have excessive slack,
be pinched, or interfer with adjacent or sur-
rounding parts in all steering positions.
11 1-9