Clutch Slave Cylinder - Honda V65 MAGNA 1985 Manual

CLUTCH
ASSEMBLY
CAUTION:
Handle the master piston, spring, primary
cup. and secondary cup as a set.
Coat all parts with clean DOT
-4
brake fluid before
assembly.
Install the spring, primary CUp. and piston.
CAUTION:
When installing the cups, do not a/low the lips
to turn inside out.
Install the circlip mlking sure
it
is seated firmly in
the groove.
Install the boot and push rod.
Install the clutch switch, if
it
was remoyed.
'83, '84:
•
After '84:
, RESERVOIR COVER
I,
DIAPHR"'GM
~
/ MASTER CYLINDER
~~
flOLOER
<:...;:,'
« >-~
..
'" Sll'RING
~~
_
~../;r:.:.
f.
~
7".(
CLUTCH , PISTON "'NO
II'
SWITCH
~ SECOHO"'RY CUI'
K'::.'", , , , ,
Place the master cylinder on the handlebar and
install the holder and the two mounting bolts.
Aligh the end of the nolder with the punch mark on
the handlebar.
Tighten the top bolt fint then the bonom bolt.
TOROUE: 10-14 N·m <1.0-1.4 kg-m, 7-10 ft-lb)
Install the oit hose with the bolt and its two sealing
washers.
Install the push rod end piece into the clutch lever
hole and install the clutch lever.
Connect the clutch switch wires to the switch
terminals.
Fill the reservoir and bleed the clutch system
(page
7-4).
CLUTCH SLAVE CYLINDER
OISASSEMB LY
Remove the left crankcase rear cover.
7-8
CLUTCH HOSE
PUNCH MARK
CRANKCASE REAR COVER