Main Bearings - Honda V65 MAGNA Shop Manual

V65MAGNA
CRAN KSHA FT/P ISTON
MAIN BEARINGS
Inspect the bearing inserts for damage or separation.
Clean all oil from the bearing inserts and journals.
Put a piece of plastigauge on each journal, avoiding
the oil holes.
PLASTIGAUGE
Install the main bearings on the correct journals
on the lower crankcase and tighten them evenly
in 2-3 steps in the sequence shown.
TORQUE VALUES:
6 mm bolt: 10-14 N·m
(1.0-1.4 kg-m, 7-10 ft-Ib)
8
mm bolt:
21-25
N·m
(2.1-2.5
kg-m,
15-18
ft-Ib)
10 mm bolt: 43-47 N·m
(4.3-4.7
kg-m,
31-34
ft-Ib)
NOTE:
Do not rotate the crankshaft during inspec-
tion.
Remove the lower crankcase and measure the com-
pressed plastigauge on each journal.
OIL CLEARANCE SERVICE LIMIT:
0.07 mm (0.003 in)
Date of Issue: Dec, 1982
© HONDA MOTOR CO., LTD.
173
1 -9