JRC JCY-1800 Instruction Manual page 72

4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
4.8.3.3. Checking setup data
Confirm that there is no blank in setting data.
1) Entry lamp
Defect in setting entry (Model, Serial number, etc.) as warning can be displayed to the
"Entry" lamp.
●
(Green):
●
(Yellow):
2) Audio Quality lamp
Result of judgment to audio quality is displayed to the "Audio Quality" lamp.
●
(Yellow):
●
(Green):
●
(Red):
4.8.3.4. Transmitting setup data
Transmit the setup data to the RCU.
• Transmit
Click the [SET] button.
• Cancel
Click the [Close] button.
4.8.3.5. Result of diagnosis
As for the diagnostic result of the [VHF] section, a result is displayed to the "Diagnosis" lamp.
●
(Green):
●
(Red):
●
(Orange):
* Setting modified data of the "VHF" section becomes effective after the reboot of RCU.
Therefore, when a setup data is changed, do not refer to the diagnostic result before rebooting the RCU.
* The diagnostic lamp is displayed also on the SYSYTEM screen.
Click the [Reboot] button on a SYSTEM screen after completing setup, and check the diagnostic lamp of a
SYSTEM screen.
1) ARB
The operating state of data I/F of the Audio Recording Board (ARB) and the Main Control Board (MCB)
* The diagnostic function needs to be operating.
A "Diagnosis" lamp becomes a blank display when the diagnostic function is not operating.
A diagnostic function can be started with the [Diagnosis] button on "SYSTEM" screen.
DOC No. 7ZPNA4014
All entries are inputted.
The blank entry remains.
Look for a blank entry and input a setup data to blank entry.
An audio quality is not judged.
Open the "Audio quality check" screen and enter a result
of judgment.
A result of judgment for audio quality is good.
A result of judgment for audio quality is no good.
Result of diagnosis is good.
Result of diagnosis is no good.
Under a diagnosis
66