JRC JCY-1800 Instruction Manual page 53

4.5.6.2.1. Identification of Analog signal output Equipment
Set a information data of connected Analog signal output equipment.
1) Equipment
Enter the name of the connecting equipment.
2) Model
Enter the model name of the connecting equipment.
3) Manufacturer
Enter the name of the manufacturer of the connecting equipment.
4) Serial No.
Enter the serial number of the connecting equipment.
* The old equipment by which the serial number is not displayed also exists. In that case, enter "unknown" into
the Serial No. column.
4.5.6.2.2. Setup of Analog signal Specifications
Set up a "Volt/Current", a range, etc. by the strap on PCB (ACB: CEF-60).
It does not set up with maintenance software.
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
47
4. Installation, Setup and Check
DOC No. 7ZPNA4014