JRC JCY-1800 Instruction Manual page 135

e) If execute horizontal position tuning at this point, click the [Yes] button. If retry to point the image, click the [No]
button and click the horizontal edge of the image.
Shifted the horizontal setup, and captured the image. The result message appears.
f) Click the [OK] button on message box.
11.3.2.2. By the manual
a) Click the [Tuning (T)] -> [Horizontal POSI. manual] menu.
The following message appears.
b) Click the [OK] button on message box.
Automatically captured the image and the following message appear.
c) If the image will be moved left, click the [Yes] button. If the image will be moved right, click the [No] button. If
will be end the tuning, click the [Cancel] button.
Shifted the horizontal setup, and captured the image. And the message appears.
d) Repeat the step c) to the right position.
11.3.3. Vertical position tuning
If the captured image shifted vertical, tune the Vertical position. If the captured image large shifted, tune by the
mouse. If the small shifted, tune by the manual. The vertical position tuning procedure is same as that the Horizontal
position tuning. Use the [Vertical POSI. Mouse] or [Vertical POSI. Manual] menu, and refer to Horizontal position
tuning procedure.
11. Frame Grabber Board (CKA-137) setup - FGB utility -
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
129
DOC No. 7ZPNA4014