JRC JCY-1800 Instruction Manual page 43

● State of a dry contact signal
The condition of the equipment shown by OPEN/CLOSE of a dry contact signal is set up.
1) Alarm
Select the inputting dry contact state (OPEN/CLOSE) when the connected equipment is a normal state.
2) Door
Select the inputting dry contact state (OPEN/CLOSE) when the connected door is open.
● creating sentence data
Select each factor which constitutes sentence data.
1) Dry contact information
Select the dry contact information from the pull-down menu of each category according to the connected signal.
Although categories are prepared to 3 at the maximum, number of category to be set up is automatically
determined by selected data.
Be sure to select a dry contact information from the pull-down menu which can be set up.
An unnecessary setup category is in an input prohibition state.
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
37
4. Installation, Setup and Check
DOC No. 7ZPNA4014