Control Techniques Commander SE Advanced User's Manual page 91

12.10
This bit is used to select one of two variables. Users wishing to make the change by external control should program a
terminal to control this bit.
12.11
0.00 ~ 21.51
*Units: Menu.Parameter
This parameter defines the parameter that the variable selector is to control. Only parameters which are not protected can be
setup as a destination. If a non valid parameter is programmed the output is not routed anywhere.
Commander SE Advanced User Guide
Issue Number: 4
Variable select bit
0 or 1 0
Variable selector destination
0.00
RW Bit
*
RW Uni R P
91