Control Techniques Commander SE Advanced User's Manual page 189

Keypad buttons set up
Parameter
99.23 F1 button assignment
99.25 F1 button destination
99.26 F1 button destination value 1
99.27 F1 button destination value 2
99.33 F3 button assignment
99.35 F3 button destination
99.36 F3 button destination value 1
99.37 F3 button destination value 2
Drive parameters set up
Parameter
7.10 Analog input 1 destination
8.21 Digital input / output destination / source
8.25 Digital input 5 destination
8.26 Digital input 6 destination
8.39 Disable auto set up
9.04 If drive is not running, potentiometer is held at zero
9.08 Invert output
9.10 Motorised potentiometer reset
9.21 Zero start select
9.23 Rate of increase / decrease
9.25 Motorised potentiometer destination
Perform a drive save routine: xx.00 = 1000 and press the Stop / Reset button on the drive.
Perform a Universal Keypad save routine: 99.00 = 1000 and press the red Stop / Reset button on the keypad.
Example 4
If it is required that control is from the Universal keypad's Stop/Start/Forward/Reverse buttons rather than the drive's
terminals, program the following parameters in addition to those already programmed using Example 3.
Keypad buttons set up
Parameter
99.05 Keypad control buttons
Drive parameters set up
Parameter
6.41 Control word mask
6.43 Control word enable
Perform a drive save routine: xx.00 = 1000 and press the Stop / Reset button on the drive.
Perform a Universal Keypad save routine: 99.00 = 1000 and press the red Stop / Reset button on the keypad.
Commander SE Advanced User Guide
Issue Number: 4
Description Value
2 Values
2 Values
Description
Description Value
Enable
Description
815
1
0
816
1
0
Value
0
9.28
9.26
9.27
1
10.02
1
09.28
1
20
1.36
Value
11
1
189