Country Codes - Grandstream Networks UCM6202 User Manual

Send This Call Through Trunk
Use Trunk
Strip
Prepend
Use Failover Trunk
Failover Trunk
Strip
Prepend

Country Codes

The UCM6200 allows users to put country code restrictions on specific outbound routes. Once the restriction is
enabled, call to the restricted country cannot be placed on that specific trunk. To configure this feature, please
navigate to web UI-> PBX -> Basic -> Outbound Routes -> Country Codes.
Select the trunk for this outbound rule.
Allows the user to specify the number of digits that will be stripped from the
beginning of the dialed string before the call is placed via the selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9 should
not be sent out via analog lines and the PSTN line. In this case, 1 digit should be
stripped before the call is placed.
Specify the digits to be prepended before the call is placed via the trunk. Those
digits will be prepended after the dialing number is stripped.
Failover trunks can be used to make sure that a call goes through an alternate
route, when the primary trunk is busy or down. If "Use Failover Trunk" is enabled
and "Failover trunk" is defined, the calls that cannot be placed via the regular trunk
may have a secondary trunk to go through.
Example:
The user's primary trunk is a VoIP trunk and the user would like to use the PSTN
when the VoIP trunk is not available. The PSTN trunk can be configured as the
failover trunk of the VoIP trunk.
Allows the user to specify the number of digits that will be stripped from the
beginning of the dialed string before the call is placed via the selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9 should
not be sent out via analog lines and the PSTN line. In this case, 1 digit should be
stripped before the call is placed.
Specify the digits to be prepended before the call is placed via the trunk. Those
digits will be prepended after the dialing number is stripped.
UMC6200 Series User Manual
P a g e | 166