The UCM6200 supports conference bridge allowing multiple bridges used at the same time:
UCM6202/6204 supports up to 3 conference bridges allowing up to 25 simultaneous PSTN or IP
participants.
UCM6208 supports up to 6 conference bridges allowing up to 32 simultaneous PSTN or IP participants.
The conference bridge configurations can be accessed under Web GUI->PBX->Call Features-
>Conference. In this page, users could create, edit, view, invite, manage the participants and delete
conference bridges. The conference bridge status and conference call recordings (if recording is enabled)
will be displayed in this web page as well.
Conference Bridge Configurations
Click on "Create New Conference Room" to add a new conference bridge.
Click on
to edit the conference bridge.
Click on
to delete the conference bridge.
Extension
Configure the conference number for the users to dial into the conference.
When configured, the users who would like to join the conference call must enter
this password before accessing the conference bridge.
Password
Note:
Configure the password to join the conference bridge as administrator. Conference
administrator can manage the conference call via IVR (if "Enable Caller Menu" is
enabled) as well as invite other parties to join the conference by dialing "0"
(permission required from the invited party) or "1" (permission not required from the
Admin Password
invited party) during the conference call.
Note:
CONFERENCE BRIDGE
Table 58: Conference Bridge Configuration Parameters
If "Public Mode" is enabled, the password is not required to join the conference
bridge thus this field is invalid.
The password has to be at least 4 characters.
If "Public Mode" is enabled, the password is not required to join the conference
UMC6200 Series User Manual
P a g e
|
174