Sample Configuration; Figure 106: Enable Sla Mode For Analog Trunk - Grandstream Networks UCM6202 User Manual

Ring Delay
Hold Access

Sample Configuration

1. On the UCM6200, go to web UI->Basic/Call Routes->Analog Trunks page. Create analog trunk or
edit the existing analog trunk. Make sure "SLA Mode" is enabled for the analog trunk. Once enabled,
this analog trunk will be only available for the SLA stations created under web UI->Basic/Call Routes-
>SLA Station page.
Configure the time (in seconds) for delay before ringing the station when a call
first coming in on the shared line. No delay is set by default. If set to 0, there will
be no delay.
This option defines the competence of the hold action for one particular trunk. If
set to "open", any station could hold a call on that trunk or resume one held
session; if set to "private", only the station that places the trunk call on hold could
resume the session. The default setting is "open".

Figure 106: Enable SLA Mode for Analog Trunk

UMC6200 Series User Manual
P a g e | 162