The UCM6200 supports SLA that allows mapping the key with LED on a multi-line phone to different
external lines. When there is an incoming call and the phone starts to ring, the LED on the key will flash in
red and the call can be picked up by pressing this key. This allows users to know if the line is occupied or
not. The SLA function on the UCM6200 is similar to BLF but SLA is used to monitor external line i.e., analog
trunk on the UCM6200. Users could configure the phone with BLF mode on the MPK to monitor the analog
trunk status or press the line key pick up call from the analog trunk on the UCM6200.
Create/Edit SLA Station
SLA Station can be configured on web GUI->PBX->Basic/Call Routes->SLA Station.
Click on "Create New SLA Station" to add a SLA Station.
Click on
to edit the SLA Station. The following table shows the SLA Station configuration
parameters.
Click on
to delete the SLA Station.
Station Name
Station
Available SLA Trunks
Selected SLA Trunks
SLA Station Options
Ring Timeout
SLA STATION
Figure 105: SLA Station
Table 55: SLA Station Configuration Parameters
Configure a name to identify the SLA Station.
Specify a SIP extension as a station that will be using SLA.
Existing Analog Trunks with SLA Mode enabled will be listed here.
Select a trunk for this SLA from the Available SLA Trunks list. Click on
to arrange the order. If there are multiple trunks selected, when there are
calls on those trunks at the same time, pressing the LINE key on the phone will
pick up the call on the first trunk here.
Configure the time (in seconds) to ring the station before the call is considered
unanswered. No timeout is set by default. If set to 0, there will be no timeout.
UMC6200 Series User Manual
P a g e
|
161